9/4/2023 0 Comments Red light digital clock![]() ![]() If the clock sets to the correct time, it’s a signal issue at its original installation location. A reset causes the clock to scan for a broadcasting Transmitter frequency. Press and release the clock's reset button in its setting panel. Apply power to the clock experiencing the issue. Take the clock with the issue to a known good signal area with clocks that are set to the correct time with a solid colon. If a clock(s) continue not to set its time, it may be due to the signal coverage at the install location or area. ![]() Once the Transmitter is in a normal state, the clocks will receive and synchronize their time at their next scheduled signal search. Is the Transmitter red LED flashing and/or is the information displayed on the front LCD not correct? If yes, the Transmitter is in an error state that may result in the clocks not receiving a time signal. A small screw driver can be used to gently pry the center top edge of the panel forward. Setting panel Classic Series (discontinued): From its front side, remove the small rectangular access panel located in the upper center. Setting panel Levo Series (current model): From its backside, remove the small rectangular access panel. Press and release the button located in its setting panel. Reset the clock to initiate a manual signal search. Identify scope of clocks experiencing issue - single clock or all clocks/clocks in specific area. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |